Tips on how to Reset BMW 540i Codes 1Turn your 540i off and take away the essential from the ignition.2Lift the trunk on your 540i Auto diagnostics. Open the battery and fuse compartment positioned on the passenger side with the trunk.
3Loosen the unfavorable battery clamp from the battery, utilizing the 10mm socket wrench. The negative clamp is marked using a minus sign. Eliminate the clamp and wait for a single minute.4Reattach the clamp for the battery and tighten it using the 10-mm socket wrench.
5Start your 540i and wait for all the startup warning lights to go off. Confirm that the verify engine light goes off as well.6Place the cover back on the battery and fuse compartment. Close the trunk. Tips on how to Reset BMW Service Lights 1Remove the fuse panel cover and find the 15-pin or 20-pin diagnostic connector.
2Plug the reset tool in to the connector input.3Turn the BMW ignition to the "II" position, but tend not to crank the engine.4Wait 15 seconds till all the service lights have been reset. The indicator light on the tool must cease blinking at this point Obd2 scanner.
Related articles:
没有评论:
发表评论